These are all the parts you need to print to build your own Campfyre.
This is the multi-page printable view of this section. Click here to print.
Printable Parts
Parts to print for your Campfyre
- 1: Battery Holder
- 2: DCDC-8A Mount
- 3: Epic PWRGate Mount
- 4: Starlink Mount Corner A
- 5: Starlink Mount Corner B
- 6: Starlink Mount Half
- 7: Voltmeter Mount
1 - Battery Holder
This is a predesigned holder for 150x65mm batteries. These are common LiFePO4 batteries found in uninterruptable power supplies, and can be ordered from the supplier listed in the components page.
2 - DCDC-8A Mount
The DCDC-8A Mount is the mount that holds the DCDC-8A in the case, allowing for it to be removed by unscrewing it rather than having it permanently affixed directly into the case.
3 - Epic PWRGate Mount
The Epic PWRGate is the power path controller which selects the power source to use for supplying the rest of Campfyre.
4 - Starlink Mount Corner A
This is what screws into the Starlink Mount to hold the Starlink Mini in place. Print two of these for Campfyre.
5 - Starlink Mount Corner B
This is what screws into the Starlink Mount to hold the Starlink Mini in place. Print two of these for Campfyre.
6 - Starlink Mount Half
This is the base that attaches to the case, to which the Starlink is then attached. Print two of these for Campfyre.
7 - Voltmeter Mount
This attaches the voltmeter (and associated pushbutton) to the side of the case, so you can check the battery voltage.